USB to Ethernet™ 10/100BaseT Adapter

Introduction:

The USB 2.0  Ethernet™ 10/100 adapter performs good PnP connection of PC peripherals "out-side the box" and mark a significant advance in desktop cable management. Using the USB 2.0 Ethernet™ 10/100 adapter you can simplify your PC network connections in the home, office. 

• Specification:-
  • Standard : USB Rev.2.0
  • IEEE 802.3 MII compliant
  • Supports USB Suspend/Resume detection logic.
  • Full-Speed USB Device
  • Supports Wake up frame, link status change and magic packet wake-up
  • Supports automatically load vendor ID from EEPROM
  • Supports up to 32K - byte external SRAM and 2k - byte internal memory.
• System Requirement:-
  • IBM™ PC or compatible PC with 486DX-100MHz CPU or higher
  • Available USB ports
  • AT least 16Mb or Dram
  • Windows™ 98, ME, 2000 

• USB peripherals can connect either to a computer's port or to a hub.
• If the computer doesn't have enough ports for all the peripherals, a hub is necessary.
• Maximum length on individual cables is 5 Meters.
• No terminators are needed on this bus.
• The A (flat) type port would be considered the "out" port on a computer or hub.
• The B (square) type port would be considered an "in" port on hubs or peripherals.
• A typical USB "out" (Type-A) port can provide up to 500mA.
• The speed is 12 Megabytes per second for USB 1.1 or 480 Megabytes per second for USB 2.0, the maximum number of peripherals to a controller is 63 (hubs needed when the computer runs out of ports).